HOMEOWNERS GUIDE
Bath with Airjets
1096755-5-
D
6 of 16
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
USER KEYPAD AND BATH WITH AIRJETS MODES/FEATURES (CONT’D.)
User Keypad “Sleep” Modes -
To enhance your bathing experience, the keypad is programmed to
darken after approximately 15 seconds of inactivity. Only the last feature selected will remain illuminated.
To resume normal operation, press any key or turn the outer ring. Approximately 60 seconds after all
equipment is turned off, the keypad will darken completely to conserve power. Press the power button or
turn the outer ring to reactivate the keypad.
OPERATING YOUR BATH WITH AIRJETS
Rotating Ring Key Pad
Purge Mode
Decrease Flow or Surge
Indicator Bar
Increase Flow or Surge
Surge Mode
Zone 3
Power On/Off
Zone 1
Air Flow Mode
Activates Mode Selected
Zone 2
Rotate outer ring to
access desired mode.
Starting the Unit
If the unit does not function properly, please refer to the “Troubleshooting” section.
Close the drain.
Fill the bath to a level at least 2” (51 mm) above the top of the airjets.
Use your hand to test the water temperature for comfort and safety.
Carefully enter the bath basin.
Press the On/Off button on the user keypad.
Observe that the air system starts and air begins to
fl
ow to all zones.
If desired, adjust the air
fl
ow rate using the up button or the down button.
After about 15 seconds, observe that only the last feature selected remains illuminated on the user keypad.
Selecting Air Flow Modes
Rotate the outer ring to select a desired mode.
Observe that the selected icon is
fl
ashing blue.
Press the
″
OK
″
button to activate the mode.
Observe that the active mode
fl
ashes green and the mode is implemented.
Observe that, after about 15 seconds, the icon stops
fl
ashing.
