HOMEOWNERS GUIDE
Bath with Airjets
1096755-5-
D
7 of 16
Questions? Problems? For additional assistance, please contact KALLISTA’s Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or FAX 1-888-272-3094.
OPERATING YOUR BATH WITH AIRJETS (CONT’D.)
To turn off a mode, rotate the outer ring until the icon
fl
ashes green and then press the “OK” button again.
The icon will then turn blue indicating the mode is off.
Stopping the Bath
When ready, press the power button a second time to stop the air system.
Carefully exit the bath.
Open the drain to empty the bath.
Observe that, when the bath drains below the level sensors, the automatic 2-minute purge cycle occurs.
The air system operates at a low speed to blow any residual water out of the air channels.
Observe that, about 60 seconds after shutdown, all user keypad lights extinguish.
Initiating a Manual Purge Cycle
After stopping the air system and draining the bath, rotate the ring on the user keypad to the purge icon.
Observe that the purge cycle icon is
fl
ashing blue.
Press the
″
OK
″
button once.
The purge icon
fl
ashes green and the mode is implemented. The air system operates at a low speed to
blow any residual water out of the air channels.
After about 2 minutes, the air system stops automatically.
CARE AND CLEANING INSTRUCTIONS
Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances could block
the airjets.
Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning solutions can
damage the bath surface.
Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents can damage
the bath surface.
Wipe out your acrylic bath with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
NOTE:
To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub
scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not
wax areas where you walk or stand.
Cleaning Your User Keypad and Remote Control
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty, use a
non-abrasive soap and warm water to clean.