59
GB
Following the principles of operation of the various hydraulic diagrams.
Important considerations:
•
healthcare will always have priority
•
There are three types of stand-by:
Type 01
: the ambient temperature detected by the probe on the board has reached the SET AIR set
Type 02:
the water temperature in the boiler has reached the SET H2O set
Type 03:
the external thermostat has detected that the desired temperature has been reached and therefore the
contact is open.
In this specific case the boiler behaves as follows:
If the thermostat carries voltage to the card causing faults, the warranty will expire.
To configure the thermostat, simply remove the jumper on the THERM terminal (see the tab on page 16) and connect our
room thermostat, OPERATION BY A SPECIALIZED TECHNICIAN.
How to select the type of Stand-by (OPERATION BY A SPECIALIZED TECHNICIAN):
Press the SET button; press button
to go to menu 09. Press the SET button again. Enter the access key and confirm
it by pressing the SET key again. Press the
key to go to menu 9-5.
The display will show the different stand-by modes mentioned above, choose the mode using the
and
keys.
NOTE: The hydraulic scheme 00 is set by default, the WINTER season with stand-by mode 02.
When the stove is switched off manually or by programming, automatic ignitions exit from a stand-by state will not be
possible.
How to enable or disable the stand-by mode:
Press the SET button. With the
., key, go to menu 05 and confirm with the SET key. Use key
sto select whether
to enable (ON) or disable (OFF) the boiler stand-by function.
Press the ON / OFF button to exit
Let’s see specifically the behavior of the boiler according to the hydraulic scheme, the presence and the
stand-by mode and the chosen season
Summary of Contents for Alessia
Page 47: ...93 GB NOTES Cod 001143...
