Kalor Chiara 15, User Manual

12

Pict. 11: back

1. Fuse F4AL250V

2. Electrical feed cable

3. Lighting button

4. Thermostat reset button

5. Environmental probe

1

2

3

4
5

8.0 Failure on electrical devices

Mancata accensione

If the flame does not light up during the switching on or if the smokes temperature does not reach a suitable value in the 
foreseen time gap, the insert switches off and you will read the words “

N O   L I G H T I N

”.

on the display. Press the key “On/Off” to reset the alarm. Wait until the cooling phase is completed, clean the brazier and 
start a new light-up.

Switching off while working

The insert suddenly switches off while working (for example because it has run out of pellets in the tank or because the 
motor reducer for pellets loading got broken). The insert continues working until the pellets left in the brazier ends. You will 
then read the words “

n o   p e l l e t

“on the display and the insert switches off. Press the key “On/Off” to reset the alarm. 

Wait until the cooling phase is completed. Clean the brazier and start a new light-up.

These alarms remind you that the brazier must be cleaned and installed correctly before switching 
on the insert.

There is no power supply

In the event of a power drop longer than one minute, the insert can exhaust some smoke in the room: this causes no 
risks. As soon as you have the power supply again, the insert will have the words ”

B L A C K   O U T

” on the display. After 

completing the cooling phase, the insert will start up again automatically according to the previous settings.o precedente 
all’assenza di

elettricità.

Do not attempt to start the insert before the required time or it may get blocked. If 
this occurs, switch off the switch on the back of the pellet insert insert for 1 minute, 
set it on again and wait 10 minutes before starting the insert again.

The power socket where the insert is connected should be fitted with “earth 
connection complying with regulations in force.” The Manufacturer shall not be held 
responsible for damage to things or people resulting from negligent installation.

EN