112
Scheme 02 :
the Hydro insert is connected to a technical w
ater puffer
.
The Hydro insert is switched off when the lower contact (thermostat) is satisfi
ed.
The Hydro insert is switched on when the upper and lower contacts (thermostat) are not satisfi
ed.
The heating w
ater will then be tak
en from this puffer by means of the pumps and the relays are not controlled by the Hydro insert control unit.
a)
a)
To set the Hydro insert w
ater temper
ature
, press the
. Increase or decrease the degrees with the
and
.
b)
To set the desired temper
ature in the room (using the probe on the board) press the
ke
y.
Increase or decrease degrees with the
and
ke
ys.
c)
To set the work power
, press the
k
ey and adjust it with the k
eys
and
.
The rinsing from the stand-by state occurs automatically when a heat increase is required to return to satisfy the chosen stand-by condition (when this is set to ON)
or when there is a risk of hot w
ater inside the puffer
.
II
I
The scheme is indicative and w
ants to
demonstr
ate only the components that
can be managed by the Hydro insert.
Any relay pumps must be controlled
separ
ately from the Hydro insert.
I
=
ON / OFF higher thermostat
on
Technical w
ater Puffer
.
II
=
ON / OFF lower thermostat
on
Technical w
ater Puffer
.
EN
Summary of Contents for Cloe 17B
