Kalor Denia 14, Installer And User Manual

53

GB

The stove is clogged 
early in the brazier 
with burning irregular, 
door glass gets dirty, 
the flame is long, red-
dish and weak

1. Flue with presence of stretch-

es too long or clogged

2. Too pellet
3. Excessive pellet or ash depos-
its in the brazier
4. The brazier is not found in its 

slot

5. Wind contrary to the exhaust 
flow
6. Insufficient combustion air
7. You changed the type of pel-

lets used

8. Smoke extractor motor broken
9. Door closed incorrectly

1. Perform periodic cleaning. See paragraph stove 
installation in the user manual. Check chimney 

cleaning

2. Decrease in the parameters the charge level of the 

pellets

3. Clean the brazier after waiting for the total shut-
down of the stove. 

If you repeat contact your 

Authorized Service Center

4. Check that the hole in the brazier matches the 

glow plug

5. Check the chimney cap windproof and / or pos-
sibly install it
6. Check the correct position of the brazier, its clean-
liness and check that the air intake in both free envi-
ronment, verify the status of the door seal, increase 
the level in the parameter relative to the speed of 
the fan exhaust fumes. 

Contact your Authorized 

Service Center

7. Check the quality of the pellets. 

Contact your 

Authorized Service Center

8. Increase the level in the parameters relating to the 
speed of the fan exhaust fumes. 

Check and eventu-

ally replace motor

9. Check that the glass is sealed and the seal guar-
antees tightness

Smell of smoke in the 
environment. Turning 
off the stove.

1. Poor combustion
2. Malfunction of fan fumes
3. Installation of the flue per-
formed incorrectly
4. Clogged chimney

1. Contact your Authorized Service Center
2. Contact your Authorized Service Center
3. Contact your Authorized Service Center
4. Contact your Authorized Service Center

In the automatic posi-
tion the stove always 

runs at full power

1. Room thermostat set to maxi-

mum

2. Significant temperature sensor 

failure

3. Control panel defective or 

broken

1. Reset the thermostat temperature
2. Check the operation of the sensor and replace if 
necessary
3. Check the control panel and replace if necessary

The engine smoke 
extraction does not 

work

1. The stove has no voltage
2. The motor is broken
3. The board is defective
4. The control panel has failed

1. Check the supply voltage and the protection fuse.
2. Check the motor and capacitor and replace if 
necessary.
3. Replace the circuit board.
4. Replace the control panel.