Kalor Denia 14, Installer And User Manual

54

GB

The manufacturer of the stove any liability and will void the warranty terms of the product for any 
inconvenience caused by not following the rules described above. Any work of service center will 
be borne by the applicant if they are not complied with these instructions.

The fire goes out or 
the stove stops auto-
matically

1. The pellet tank is empty
2. No power
3. Pellets not being fed
4. Excessive deposit of ashes in 
the grate
5. Intervention probe temperature 
safety of the pellet
6. Cochlea blocked by dirt
7. The door is not closed prop-
erly or gaskets worn
8. Pellet inadequate

9. Low pellet

10. Chimney or drain clogged 
with nests or foreign bodies
11. Pressure switch cuts
12. Smoke extraction motor 

failure

13. Alarm active

1. Fill the tank with pellets
2. Check plug and presence electricity
3. Fill the tank with pellets
4. Clean the brazier
5. Let the stove cool down completely, reset the 
manual reset and restart the stove. If the problem 
persists, contact your authorized service representa-

tive

6. Pull the plug, empty the tank, remove any foreign 

objects

7. Close the door or replace the gaskets with original
8. Change the type of pellet recommended by the 

manufacturer. 

Sometimes, depending on the type, 

the stage of adjustment of the parameters need 
to vary the level relating to the loading of pellets

9. Increase the level in the parameter for the pel-
let feed. T

o check the flow of fuel from technical 

authorized

10. Eliminate all foreign matter from the chimney 
Clean the smoke duct. Perform periodic cleaning.

11. Verify potential smoke duct is blocked and if 
the pressure switch is working properly
12. Check and replace the motor if necessary

13. See paragraph alarms

The air fan convention 
(ambient air) never 

stops

1. Temperature sensor tempera-

ture control defective or broken

2. Smoke probe fails

1. Check the operation of the sensor and replace if 
necessary
2. Replace smoke probe

The stove does not 
light.

1. Lack of electricity
2. Probe pellets in bulk
3. Fuse blown
4. Pressure switch broken (lock-
out indicated)
5. Smoke outlet or duct clogged

1. Check that the electrical outlet is plugged in and 
the power switch to "I"
2. Lockout by resetting the rear thermostat, 

replace 

the thermostat

 if it happens again

3. Replace the fuse

4. Replace the pressure

5. Clean the smoke outlet and / or smoke duct