34
GB
Function chrono-thermostat
(available only through the remote control)
With the function chrono-thermostat, you can schedule
up to two automatic switching on and off of the stove per
day.
If you want to repeat the switching on and off every day,
then you need to use the function AUTO too (as explained
in the paragraph “Daily repeat AUTO”).
Program 1 (ON1 and OFF1)
Automatic switching on ON1
Please
join
the
following
procedure to set the time for
the automatic switching on
according to the program 1:
Press the key
(1). You will
see the hours and minutes and
the symbol ON1 blinking on the
remote control. Use the keys
(2) and
(3) to change
the wished time (intervals of
10 minutes). To scroll the time
faster, keep the keys
(2)
and
(3) pressed.
Confirm your selection pressing
the key
(1) once again.
You will now read the set switching on time on the remote
control. Press SEND (4) to transmit your selection to the
pcb of the stove.
The LED chrono-thermostat will light up on the control
board indicating that the programming is on (5).
AL C
AL F
5
1
3
2
ON 1
4
• The time of the automatic switching on
and off must be set when the remote
control is Off;
• In the event of an even very short lack of current,
you will miss the set time for the automatic
switching on or off. Once the power supply is
back, please program the stove again using the
remote control;
• The stove switching on at the scheduled time will
keep the same temperature and power you set
before you last switched it off;
• Please consider an interval of min. 20 minutes
between the switching off and subsequent
switching on of the stove. In this way the unit
will have time to arrange a complete cooling
phase; in the event this minimal interval is
not calculated, the stove will not switch on as
scheduled.
Automatic switching off OFF1
Press the key
(1). You will
see the hours and minutes and
the symbol OFF1 blinking on the
remote control. Use the keys
(2) and
(3) to change
the wished time (intervals of
10 minutes). To scroll the time
faster, keep the keys
(2)
and
(3) pressed.
Confirm your selection pressing
the key
(1). once again.
You will now read the set
switching off time on the remote
control. Press SEND (4) to
transmit your selection to the pcb of the stove.
The LED chrono-thermostat will light up on the control
board indicating that the programming is on (5).
The LED chronothermostat switches off as soon as the
automatic switching on and off are completed.
The remote control does not show the previously set time
schedule anymore.
OFF1
1
3
2
4
Program 2 (ON2 and OFF2)
As above but with the keys
ON2 and OFF2
Cancel any eventual already
set timetables.
Please join the following
procedure to cancel any other
already set timetables. This
example refers to the automatic
switching off of the program
1 (Off1). The procedure is the
same for all plans.
Press the key corresponding to
the switching on or off time you want to cancel.
Referring to the example: press the key
(1).
You will see the hours and minutes and the symbol OFF1
blinking on the display of the remote control. Now press
the key “CANCEL” (2) to cancel the automatic switching
on or off timetables from the display.
Press the key SEND (3) to confirm your selection and
transmit it to the pcb of the stove.
2
1
3
