Kalor Paola 13, User Manual

6

Preliminary checks

Before switching on the pellet Insert, make sure that the pellet hopper is full, the combustion chamber is clean, the glass door 
is closed, the power supply plug is connected and the switch on the back is set to “1.”

21 : 10

22°C    P-1

TURNED OFF

14 : 35

22°C    P-1

FIRE
present

14 : 35

21°C    P-2

LOAD
pellet

15 : 18

22°C    P-3

WORK

TURNED OFF
The Insert is off.

TURNED ON
The Insert is in the fi rst ignition 
phase. The glow plug and fume 
extractor are active.

LOAD PELLET
In this phase of the ignition process 
the Insert starts loading the pellets 
into the brazier. The glow plug, the 
fume extractor and the cochlea 
engine are active.

FIRE PRESENT
In this phase of the ignition process 
the Insert starts loading the pellets 
into the brazier. The fume extractor 
and the cochlea engine are active.

BRAZIER CLEANING
The Insert is cleaning the basket.
The smoke extractor runs at 
maximum speed and the pellet 
load is at minimum.

WORK
The Insert is working, in this case 
at power 3. The detected room 
temperature is 21 ° C. During 
normal work, the fumes fan, the 
auger motor and the room fan are 
active.

14 : 35

21°C    P-2

ACCENDE

ON STAND BY
All the requests have been 
satisfi ed and the insert is ready for 
the “STAND BY” mode.

HOLD REQUEST
The insert is in a “STAND BY” 
mode as everything has been 
satisfi ed. The insert is waiting for 
an heating request to turn on. 

WAIT COOLING
The insert has to complete the 
cooling circle before turning on 
again.

21 : 10

22°C    P-1

STAND BY

14 : 35

21°C    P-2

HOLD 
REQUEST

14 : 35

21°C    P-2

WAIT 
COOLING

15 : 18

22°C    p-2

BRAZIER 
CLEANING

7.0 Display information

ATTENTION!
The insert will function during the hours of ON programming at 
the same temperature and the power settings as when it was last 
shut down.

!

EN