Kalor QUADRA 12D, User Manual

34

EN

Our company declares that the stove conforms to the 
following norms for the EC European Directive labelling:
• 2014/30 UE (regulation EMCD) and following 

     amendments;
• 2014/35 UE (Low Voltage Directive) and following 

 amendments;

• 2011/65 EU (RoHS 2 directive);
• The New Rules of Construction Products (CPR-

Construction Products Regulation) No. 305/2011 
regarding the construction world;

• For installations in Italy, please refer to UNI 10683/98 or 

following changes. 

While installing the unit respect 

the local, national and Europen rules;

• EN 55014-1; EN 55014-2; EN 61000-3-2; EN 61000-3-3; 

EN 60335-1; EN 60335-2-102; EN 62233, EN 50581.

Safety information

Please carefully read this use and maintenance manual 
before installing and operating the stove.
If clarification is needed, please contact the dealer or the 
Authorized Assistance Center.
• The pellet stove must only be operated in living 

environments. This stove, being controlled by an 
electronic board, permits a completely automatic and 
controlled combustion; the exchange, in fact, regulates 
the lighting phase, 5 power levels and the shut down 
stage, guaranteeing the safe operation of the stove.

• The basket used for combustion allows most of the ash 

produced by the combustion of the pellets to fall into 
the collection compartment. Nevertheless, check the 
basket daily, given that not all pellets have high quality 
standards (use only quality pellets recommended by the 
manufacturer).

Responsibility

With the delivery of the present manual, we decline 
all responsibility, both civil and penal, for accidents 
deriving from the partial or total lack of observance 
of the instructions contained herein. We decline every 
responsibility derived from improper use of the stove, 
from incorrect use by the user, from unauthorized 
modifications and/or repairs, from the use of replacement 
parts that are not original for this model.
The manufacturer declines every civil or penal, direct or 
indirect responsibility due to:
•  Lack of maintenance;
• Failure to observe the instructions contained in the 
manual;
• Use in non-conformity with the safety directives;

• Installation in non-conformity with the norms in force in 
the country;
• Installation by unqualified or untrained personnel;
• Modifications and repairs not authorized by the manu-
facturer;
• Use of non-original replacement parts;
• Exceptional events.

Norms and declarations of conformity

• Use only wood pellets;
• Keep / store the pellets in a cool dry 

place;

• Never pour pellets directly on the hearth;
• The stove must be fueled only with quality pellets 

with a diameter of 6 mm and a maximum length 
of 30 mm, A1 certified according to the UNI EN 
ISO 17225-2 standard, the type recommended 
by the manufacturer.

• Before making the electrical connection of the 

stove the discharge tubes must be connected 
with the flue;

• The protective grill placed inside the pellet 

container must never be removed;

• The environment where the stove is installed 

must have a sufficient exchange of air;

• It is forbidden to operate the stove with the door 

open or the glass broken;

• Do not use the stove as an incinerator; the stove 

should be used only for the intended purpose;

• Any other use is considered improper and 

therefore dangerous. Do not put in the hopper 
other than wood pellets;

• When the stove is operating, the surfaces, glass, 

handle and tubes become very hot: during 
operation do not touch these parts without 
adequate protection;

• Keep the fuel and other inflammable materials 

off the stove.