Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
16
TKG HA 1006 - 140710
Assembly page 16/64
Fax +32 2 359 95 50
d) Mixing with the blender
BE CAREFUL!
1)
Your appliance is fitted with a security device on the pouring jug allowing the
functioning of the appliance only when the jug and its lid are correctly placed on the
motor base. If those conditions are met and the appliance does not start, call your
after sales service.
2)
Your appliance is also fitted with a security device on the lid. If the lid is not fitted
correctly, the appliance won't start.
Before using the blender (3), the processor bowl (10) has to be fitted into the base and the lid
properly locked. Do not put any accessory or food into the bowl.
Unscrew the safety lid (20) to remove it.
Open the lid of the blender, put the ingredients for mixing into the blender and add the
liquid. IT IS VERY IMPORTANT that the mixture does not go above the maximum level
indicated on the blender jug (fig. 13, page 6).
Shut the lid with its cap (1) and screw it onto the blender. Make sure the assembly has
been done properly (the lid and the bowl have to be locked).
Place the blender jug (3) on its connector switch (4) (fig. 14, page 6) and turn it clockwise
until the handle is oriented to the left and the jug is properly fixed to the motor unit (fig. 15,
page 6).
Always respect the order of assembly as described above: first put the lid on the blender
jug, then the jug on the base. Otherwise you could damage the safety system. If one of
these two parts or both of them are mounted badly, the appliance will not function.
Depending on the type of food, you can prepare up to 1.2 l with the blender.
Plug in the appliance and turn the ON/OFF & speed switch to the desired speed or use the
pulse button depending on the preparation.
Never use the processor and the blender simultaneously.
Once the mixing is done, turn the ON/OFF & speed switch to “0” and unplug the
appliance. Wait until the blender has come to a complete stop before removing the jug.
When you use your appliance in an intensive way, it is necessary to make breaks of at
least 1 minute between every operation to let the motor cool down.
Caution
: your appliance is not designed to mix hot preparations and the plastic bowl
could break otherwise. If nevertheless you wish to prepare hot drinks or soups, let the
whole cool down to a temperature lower than about 60°C (tepid preparation) before
pouring it into the plastic bowl. In case the lid would come up in spite of the precautions
mentioned in section "Important safeguards", you can also empty part of the preparation
and mix it in several times.
CLEANING
Cleaning the blender
Place the blender jug onto the motor unit as indicated in the paragraph “mixing with the
blender”.
Leave the processor bowl and its lid into place. Do not put any accessory or food into the
bowl.
Pour a little bit of hot soapy water into the blender jug. Then press the pulse button (5) for
a few seconds.
Unplug the appliance, remove the blender jug and rinse it out.
Use a sponge if necessary. Be careful not to hurt yourself with the blades.
Rinse the blender jug out once more and let it dry.
