Connect the power cable to a 13 amp supply which is
located in a safe, dry area.
The switch on the heater is used to control the Heater.
When the switch is in position, the standby light will
be turn orange, the heater will be in standby mode. The
position will turn off the Heater.
Operation
Control Panel
The Remote Control
1. Aim the remote control at the display window on
the control panel
2. Press
once, the display window show P5. Press
twice, the display window show P9. Press
three times, turns off the heater.
3. Press
, the display window shows P1. Press
again and the mode will increase up to P9. Press
again and the mode will shift down until the
heater switches off.
4. Press
at any working mode to enter timer
selection mode. Press
again and the timer cycle
will change from 1 to 24 Hours. Wait for 3 seconds
and to confirm the set time automatically.
Display Window
