PREPARATIONS
1. Checking the Contents
Check that the carton contains the following items:
1) Main unit
2) Control unit
3) Operating instruction (this booklet)
4) RCA pin cord.
5) Control cords
2. Installing the Unit
Mount the unit into your console or rack with 19" EIA rack rails.
CAUTION:
The player will work normally when the main unit is
mounted with the front panel at within 15 degrees of
the vertical plane. If the unit is tilted excessively, discs
may not be loaded or unloaded properly.
(Figure 1)
The control panel's LCD’s are designed to be clearly
visible within the angles shown in Figure 2. Mount the
control unit so that the visual angle is within this range.
Max.
15
°
Main unit
Control
panel Button
Figure 1 Figure 2
.
Connections
1) Turn off the POWER switch.
2) Connect the RCA pin cord to the input on your mixer.
3) Connect the control cords to the REMOTE connector on the main unit.
CAUTION:
•
Be sure to use the supplied control cords. Using another type of cable may result in damage.
•
Be sure the power is off when connecting the control cords. Otherwise the units may not work properly.
NAMES AND FUNCTIONS
Below is a description of the functions of the controls listed on Pages3 and 4.
MAIN UNIT
(1) POWER (Power ON/OFF Switch)
When the POWER switch is pressed, the power turns
on.
(2) OPEN/CLOSE
Button
Press it to open and close the disc holder. The control
unit also includes OPEN/CLOSE button. The disc
holder cannot be opened during playback, so stop
playback before pressing the button.
(3) Disc Holder
Place the discs in the holder. Press the OPEN/CLOSE
button to open and close the disc holder.
(4) REMOTE CONTROL CONNECTOR
Connect this connector to the control unit using the
included control cord.
(5) AUDIO OUT R and L
The audio signals from each player are output from
these jacks.
(6) DIGITAL OUT SOCKET
The music-signal of this socket is digital. Connect the
output to the respective input of a digital amplifier for
example.
45
5
