Thank you for purchasing this product, we hope that it serves you for many years to come.
To optimise the performance of this product, please read these operating instructions carefully to
familiarise yourself with the basic operations of this unit.
This unit has been tested at the factory before being shipped to you. There is no assembly required.
To prevent or reduce the risk of electrical shock or fire, do not expose this unit to high temperature and
rain or moisture.
Unpacking
Please unpack your new product carefully, your new product should reach you in perfect condition. Please
check that no damage has occurred during transit. If any damage is found, do not operate your unit.
Please contact the retailer you purchased it from immediately.
Safety
1. Ensure the smoke machine has sufficient fluid in the tank before plugging the unit into the mains.
2. Never allow the smoke machine to run dry of fluid when operating.
3. The smoke machine output nozzle is HOT and care should be taken to ensure that no person can touch
the smoke outlet nozzle.
4. Please note that smoke machines MAY set off fire alarms and permission should be gained from the
venue before usage of the unit.
5. This smoke machine has a thermostatically controlled safety device, if the smoke machines operating
temperature changes the unit will shut down for a short period while it either re-heats or cools down to the
correct temperature, after this time the unit will operate as normal again.
6. The smoke machine has a fluid level safety cut out, if the fluid level gets too low the LED on the rear
panel will illuminate and the machine will cut out, refill the fluid tank with smoke fluid, the LED will go out
and the machine will function again.
7. Periodically the smoke machine should be flushed clean, to do this empty the take of smoke fluid and
refill the tank half way with distilled water, operate the smoke machine until all the distilled water has been
used and then replace with ordinary smoke fluid, run the unit again until the smoke returns to normal
density.
Features
1600w heater element
Quick warm up time
High output
Thermostatic safety system built in
Large capacity fluid reservoir
Fluid level scale and safety cut out
Long range cordless remote control
DMX 512 compatible
DMX in / out sockets
4 channel selectable remote control
