Kamasa-TOOLS K 10640, Manual

7

OPERATING INSTRUCTIONS

Installing or removing battery pack 

(See Fig.1 Fig.2)

Always switch off the machine before insertion 
or removal of the battery pack.

1  To remove the battery pack, push the button on 

the battery pack and pull the tool unit from the 
battery pack.

2  To insert the battery pack, align the tool unit 

slides with the battery pack sliding groove and 
push the tool unit into place. The tool unit can 
be slipped into the battery pack in two direc-
tions.

3  Do not force the battery pack in sliding it into 

tool unit. If the battery pack does not slide in 
easily, it is not being inserted correctly. 

Charging the Battery Pack

 (See Fig.3)

1  Plug the fast charger into the power source.
2  Slide the battery pack into the charger as the ar-

row direction shown on the charger.

3  Push the battery pack into place and make sure 

the red light on the charger is “ON”. The battery 
pack is now starting the charging cycle.

4  After finish the charging cycle, the light will turn to green. The battery pack is 

now ready for use.

5  Your new battery pack is not charged. You need to charge it before use.
6  Always use the specified charger to charge the battery. When the battery 

pack is inserted into the charger correctly, the red light will come on and 
charging will begin.

7  When you charge a new battery pack or a battery pack which has not been 

used for a long period, it may not accept a full charge. This is a normal condi-
tion and does not indicate a problem. You can recharge the battery pack fully 
after discharging it completely a couple of times.

8  Unplug the charger from the power source after finish the charge.
9  Please remove the battery from the unplugged charger for storage.

Fig 3

Fig 2

Fig 1