background image

5

• 

Do not allow materials that have been 

in contact with oil, petroleum based 

products or drying fluids to come in 

contact with the heater.

• 

Do not run the cord under carpeting or 

cover the cord with rugs, runners or the 

like. Arrange cord away from traffic areas 

and where it will not be tripped over.

• 

To disconnect heater turn the power to 

OFF, then turn the control switch to off. 

Turn off at the power outlet then remove 

the plug from its outlet.

• 

Do not insert or allow foreign objects to 

pass through the inlet or outlet openings. 

This may cause an electric shock, fire or 

damage the heater.

• 

To prevent a possible fire or heat 

damage, allow ample space around the 

heater (1.7m at front and 0.5m at the 

rear, top and sides) and do not totally 

or partially block the air inlet or outlets 

in any manner. Check the openings 

from time to time for accumulated 

dust. Ensure long shag carpet does not 

obstruct airflow under the unit.

• 

Do not touch hot surfaces.

• 

Switch off at the control switch and 

power outlet, then unplug and allow 

heater to cool down before cleaning or 

storing.

• 

 Use this heater only as described in this 

instruction manual. Any other use not 

recommended by the manufacturer 

may cause fire electric shock or injury 

and voids all warranties.

• 

Regularly inspect the supply cord, plug, 

control settings, air inlets and outlets and 

main housing for any damage. If found 

damaged in any way, immediately 

cease use of the heater and return 

to Kambrook or an authorised service 

agent for inspection or repair.

NOTE:

 This Kambrook Ceramic 

Heater is electronically 

controlled and will not operate 

until the heater is plugged into 

a 230V or 240V power point and 

switched on.

Important Safeguards For All Electrical 

Appliances

• 

Fully unwind the power cord before use.

• 

Do not let the power cord hang over 

the edge of a bench or table, touch hot 

surfaces or become knotted. 

• 

The appliance is not intended for use by 

persons (including children) with reduced 

physical, sensory or mental capabilities, 

or lack of experience and knowledge, 

unless they have been given supervision 

or instruction concerning use of the 

appliance by a person responsible for 

their safety.

• 

Children should be supervised to ensure 

that they do not play with the appliance.

• 

It is recommended to regularly inspect 

the appliance. To avoid a hazard do not 

use the appliance if power cord, power 

plug or appliance becomes damaged 

in any way. Return the entire appliance 

to the nearest authorised Kambrook 

Service Centre for examination and/or 

repair, or contact Customer Service on  

1300 139 798.

• 

Any maintenance other than cleaning 

should be performed at an authorised 

Kambrook Service Centre.

• 

This appliance is for household use only. 

Do not use this appliance for anything 

other than its intended use. Do not use 

in moving vehicles or boats. Do not use 

outdoors. Misuse may cause injury.

• 

The installation of a residual current 

device (safety switch) is recommended 

to provide additional safety protection 

when using electrical appliances. It 

is advisable that a safety switch with 

a rated residual operating current 

not exceeding 30mA be installed in 

the electrical circuit supplying the 

appliance. See your electrician for 

professional advice.

KCE520_IB_FA.indd   5

12/10/09   12:10 PM

Summary of Contents for KCE520













Reviews: