Kambrook KUR10, Instruction Booklet

6

7

Your Kambrook 8 Litre Urn

1. 

Safety locking lid

2. 

Cool touch carry handles

3. 

Water window

4. 

‘POWER’ light

5. 

Variable temperature control

6. 

Non-drip tap with two way  

flow lever

Not Shown

• 

1800 watt concealed element

• 

Boil dry cut-out protection

• 

Safety reset button  

(under the base)

KUR10 Aquarius
8L Urn

KUR50 Express Cup
8L Stainless Urn

Operating Your Kambrook 8 Litre Urn

Before First Use

Remove any promotional and 

packaging materials. 
It is recommended that before the first 

use, the urn is filled to the maximum 

level, boiled and water discarded.

1. 

Fully unwind power cord.

2. 

Place the urn on a dry,  

level surface.

3. 

To fill with water, turn the locking 

lid anti-clockwise and remove 

(Fig.1).Use a small container to 

fill the urn between the minimum 

(3 litre) and the maximum (8 litre) 

marks on the water window. Too 

little water will result in the urn 

switching off. Do not fill water 

above the maximum 8 litre mark 

water window as boiling water 

may splash out from the urn.

Fig. 1

4. 

After filling the urn, ensure that the 

lid is replaced and locked firmly 

into position with the steam holes 

located on the rear side of the urn.

5. 

Plug the power cord into a 230V or 

240V power point and switch on.

6. 

Turn the variable heat control to 

‘5’ for fast boiling. The red ‘POWER’ 

light will illuminate.

7. 

When the unit has boiled, select 

the desired setting from ‘MIN’ 

to ‘4’ to maintain temperature 

(Kambrook recommends setting 

‘2’ or ‘3’ for tea or coffee). 

NOTE:

 Do not open the lid when 

in operation as steam may 

escape from top of the urn.

NOTE:

 Steam may escape from 

the steam holes on top of the 

urn. Exercise caution at all times.

8. 

To pour hot water, place a cup 

below the non-drip tap and push 

the tap down. For continuous 

pouring, lift the tap up until it is in 

the vertical position.

NOTE:

 Use caution when 

dispensing water from the urn, as 

boiling water will scald. Do not 

dispense the water too quickly.

9. 

After use and before cleaning, 

switch the appliance to  

‘STAND BY’, switch the power 

off at the power point and then 

remove the plug.

NOTE:

 The lid should always be 

fitted and locked into position 

when in use.

NOTE:

 Always empty the 

urn before moving to a new 

position/location.