Version 1.08 (04/07)
Manual: CMOS Industrial Camera LOGLUX
i5
Page 10 of 46
KAMERA WERK DRESDEN GmbH
Operation of the complete LOGLUX
i5 CL SET camera system
System requirements
The following host system (PC/IPC) requirements must be met for a safe and proper operation of the
complete LOGLUX
i5 CL SET camera system:
Minimum desktop PC system
Optimum desktop PC system
Portable PC system
(notebook)
Pentium
III or Athlon
processor >1.0GHz
Pentium
III/IV or Athlon
XP
processor >2.0GHz
Pentium
III/IV or Athlon
XP
mobile processor >2.0GHz
256MB PC133
512MB PC400
512MB PC400
>20GB hard disk with 1MB
cache
2x80GB hard disk with 2MB
cache in RAID0 mode
>40GB hard disk with 2MB
cache
Motherboard with UDMA133-IDE
interface
Motherboard with RAID
controller and FireWire
interface
-
PCI/AGP graphics card with
nVidia
400 or Radeon
7000
chipset
PCI/AGP graphics card with
nVidia
440 or Radeon
9200
chipset
Separate graphics solution with
nVidia
nForce2 or Radeon
mobility chipset
Min. 1 vacant PCI slot
Min. 1 vacant PCI slot
PCMCIA / FireWire
interface
CRT monitor or LC display with
min. contrast of 1:250
CRT monitor or LC display with
min. contrast of 1:500
LC display with min. contrast of
1:250
Operating system MS Windows
2000/XP
Operating system MS Windows
2000/XP
Operating system MS Windows
2000/XP
The system requirements for IPC systems are similar to those for desktop PC systems; for reasons of
the 'tougher' use conditions, more exclusive components may occasionally have to be chosen. For
configuring an IPC system, just contact a systems house of your choice.
With the exception of the real-time recording of large image data streams (e.g. AVI captures in full
frame and at full frame rate), normal operation of the camera will be basically possible also with a
minimum host system configuration, however, some difficulties might occur.
In view of the numerous existing PC/IPC system configurations it is impossible to guarantee that the
full scope of camera system functions can be used in every configuration. In any case, a sound basis
of a successful start-up and trouble-free operation is a minimally equipped host system (only the
graphics and framegrabber cards are installed) that meets the above-mentioned requirements and has
a newly installed operating system.
Installation of the CameraLink
™
PC plug-in card MATRIX Vision MVtitan-CL
The type MVtitan-CL CameraLink
™
PC plug-in
card is a universally applicable and powerful
framegrabbing card for any application. Its
main components are an integral image
processor (TM1300), a large memory for the
software and data (8MB standard, optional:
<=32MB), and two plug connectors for two
base
and one
medium
CameraLink
™
ports.
Please consult the manufacturer's manual
when installing the PC plug-in card.
Note:
You need to have administrator
rights for the respective PC if you want to
install hardware or software components!
Figure 7 :
MATRIX Vision MVtitan-CL PC plug-in card
