Kampmann PowerKon QE, Assembly Instructions Manual

PowerKon QE

Assembly instructions

6

4

Installation and wiring

4.1

Requirements governing the installation site

Only install and assemble the unit if the following conditions are met:

Make sure that the unit is securely suspended/standing.
Ensure that the airflow can circulate freely.
There is a power supply on site.

4.2

Installation

2 people are needed to install the unit.

CAUTION!
Risk of injury from sharp metal housing!

The inner metal of the casing can have sharp edges.

Wear suitable protective gloves.

IMPORTANT NOTE!
Install connections in the de-energised state!

Connections must be installed without tension!

Use a suitable tool to protect terminal nuts from being sheared off and
twisted.

Dimensions

Dimensions of the PowerKon QE

1

Window side

2

Room side

A

825 mm // 1250 mm // 1700 mm

B

400 mm // 835 mm // 1270 mm

Fixing points

All dimensions in mm

1) Upper edge of finished floor

22

4.2.

1

Fitting the grille

High surface temperatures occur at the electric heating coil. For this reason, additional grille fix-
ings are factory-fitted on both longitudinal sides of the duct as a safety guard. They can be re-
moved using a screwdriver. The grille fixing only needs to be removed on one side, the electrical

connection side, when wiring. Once wiring has been completed, attach the grille fixing again as

per the figure.

Installation of the roll-up grille

CAUTION:

 Do not cover the roll-up grille when the units are in operation!

5

Pre-commissioning checks

Before initial commissioning, check whether all the necessary conditions have been met so that
the unit can function safely and properly.

Electrical tests

Check whether all lines have been properly laid.

Check whether all lines have the necessary cross-section.

Are all wires connected in accordance with the electric wiring diagrams?

Is the earth wire connected and wired throughout?

Check all external electrical connections and terminal connections are fixed in place and
tighten if necessary.

Check whether DIP switches have been correctly set in accordance with the wiring diagram.