SDA
Lüftungskomponenten
Assembly, installation and operating instructions
14
Fig. 8: Fixing the SDA using a perforated strip
Use the perforated strips supplied to fix the plenum boxes to the floor.
Fig. 9: Remove the protective cover.
Remove the protective cover and dispose of it properly.
Fig. 10: Plenum box flush in the floor
Use the adjusting screws to adjust the precise height of the plenum box so
that the neck of the plenum box is flush with the floor covering.
Then finish the floor up to the plenum box.
Fig. 11: Inserting the slot outlet
Insert the slot outlet into the plenum box until the support profiles finish
flush with the floor covering.
Note: Pay attention to the correct installation position (correct air flow dir-
ection) when fitting the slot outlet!
