4
With built-in radio
If the meter is supplied with integral radio for establishment of remote reading, the
meter automatically connects to a radio network. The integral radio is equipped with
an internal antenna. The radio signal strength can be read by means of a hand-held
terminal. If the radio signal is not sufficient, an external antenna must be connected.
Please see current documentation on available antennas.
Mounting a communication module in the meter may influence communication, please
contact Kamstrup.
With disconnection function
With this type of meter, it must be checked that the red/green diode is not switched on.
This indicates that the consumer’s supply is switched off.
Installation dimensions
Connection diagrams
The valid connection diagram appears from the type label.
3-phase, 4-wire
3-phase, 3-wire (Aron)
201,6
166,9
684-38A-C4-00-010
Sn:
1
3 x230/400V
50 Hz
LED/S0:1000 imp/kWh
0,5-5(85)A
Kl. A (3) EN 62053-23
EN 50470 1/3
2007W13
40 +70C
T10063
-
-
-
201,5
166,9
5512474_E1_GB_11.2010
1 2 3 4 5 6 7 8 9 101112
L1
L2
L3
N
P+
S0 +
20
-
21
1 2 3 4 5 6 7 8 9 101112
L1
L2
L3
P+
S0 +
20
-
21
