26
6 SMS commands
NOTE
: SMS commands must be sent in
either
capital letters
or
small letters.
Capital letters and small letters must not be mixed in the same SMS command.
READ_METER - for reading a direct meter (e .g . Kamstrup 382 or 162)
Syntax
=READ_METER#
Example
=READ_METER#
Return reply, correct
Meter No. 10101010 is read, the
meter reading value is 32432 kWh,
the power is 343 W, and the meter has
operated for 2452 hours.
32432 kWh,
343 W,
2452 Hours,
Meter No.: 10101010
Return reply, error
NO ANSWER
SIGNAL - for reading the signal strength
Syntax, command
=SIGNAL#
Example
=SIGNAL#
Return reply, correct
Displays the current signal strength of
the modem on a scale of 0 to 31 where
31 is best. The signal strength must be
minimum 12.
Signal: 16(0-31)
Return reply, error
NO ANSWER
IOSTATUS - for reading of status of relay output and status/pulse input
(Note that there is only one input <input1> on this module, and the relay outputs
are an option.)
Syntax
=IOSTATUS#
Example
=IOSTATUS#
Return reply, correct
Relay1: 1 Relay2: 0
Input1: 1 Input2: 0
Return reply, error
NO ANSWER
