Operating Manual (Rev. 1)
SKORPION® Lever WS-016 type
Photo No. 5: Location of the hook and support elements
•
The position of hook [1] in the device design should be within range [2] as shown in the
photo below. As far as possible, the position of hook must be as close as possible to
the eccentric mechanism [3].
•
It is not permitted to use additional shims under the support foot [A and B]
– see photo
above; the factory applied gap is a safe distance.
•
The device is not designed for work in explosive atmospheres.
Regardless of the
stripping tool used, the cover/manhole connection is not an intrinsically safe
construction.
•
If excessive resistance is encountered during unclogging of a grate or manhole
(including damage to the hook), remove the cause of jam and retry unclogging.
•
It is forbidden to operate levers with visible or established signs of damage (including
damage to hooks
– which in this case must be replaced with defect-free ones).
The lever may be used in closed rooms and in the open air in conditions acceptable to the user.
The lever is designed for intermittent operation.
SKORPION® Lever WS-016 type
is designed for professional use
.
Page 6 of 13
