Aetos Installation Manual
13.3
Channels
Figure 62:
An example of channel D editing. Certain sensors require addi-
tional value, which defines the sensor range.
Another, slightly different example is shown on Figure 63. In this case sensor
is a thermocouple and this type requires a selection between isolated or non-
isolated type.
Figure 63:
An example of channel A editing. An EGT sensor is connected to
the channel.
Note: The functions can’t repeat themselves. When one specific function was
assigned to one channel and then the same function is assigned to the other
channel, the first assigned function will be reset and the last assigned function
will be kept.
13.3.2
Min/Max
Functions like trim position, flap position and throttle positions require two
additional parameters. After defining basic channel parameters, these two
parameters are available trough the
Min/Max
window. These two parameters
are sensor values at both extremes.
69
©
Kanardia
2019–2020
