Aetos Installation Manual
15. Offset
Figure 70:
An example of a predefined tank shape after the
Empty/Full
were
set. Non-linearity in this case is pretty severe.
Figure 71:
Software tank capacity set to 80 liters.
15
Offset
Some sensors and counters may require occasional adjustment. The offset
window allows adjustment for static and dynamic pressure sensors, CO sensor,
fuel flow correction and time counters adjustments.
Please make sure that Aetos is running for at least 10 min before any sensor
adjustments are made. This is not necessary for counter adjustments.
Static (altitude)
allows for static pressure offset.
A precise reference
static pressure must be known. Adjust the correction, so that indicated
static pressure will shown the same value as reference static pressure.
The pressure is adjusted in 0.1 hPa steps. One steps corresponds to
about 0.83 m (2.7 feet) at sea level.
Alternatively, if when reference pressure is not known, a reference al-
timeter can be also used. Set the reference altimeter baro-correction
(QNH) to 1013 hPa. If Aetos altimeter is too high regarding to the
reference altimeter, increase the correction. If Aetos altimeter is too
low, decrease the correction.
76
©
Kanardia
2019–2020
