Emsis — Manual
5.4
Emsis Setup Screen
Firmware Update
This command updates the software of devices
present on the CAN bus: AD-AHRS module (Airu), EMS module
(Daqu), compass module (Magu), etc. Do not use this function unless
we advise you to do so.
RamBoot Update
This command updates the startup software,
which takes care for the instrument start. Do not use this function
unless we advise you to do so.
Logger Settings
Here we can tune some logger specific parame-
ters. These parameters are used to identify conditions for the take-off,
landing and engine start/stop.
Figure 25:
Logger settings window
Take-off threshold specifies IAS, which must be exceeded for a
few seconds for a logger to detect and record a take-off event.
Landing threshold specifies IAS, which must be kept below for
a few seconds in order to detect the landing event. This also
works in conjunction with Rotor RPM.
48
©
Kanardia
2021