Emsis — Manual
5.4
Emsis Setup Screen
Airspeed
– is used to define IAS speed limits. PFD unit only.
When airspeeds were explicatively defined in a configuration
file, this option is not shown even in PFD case.
Units
– is used to change the units of individual parameter
groups.
Pilots
– is used to enter pilots. The pilot names are used in
logbook. PFD unit only.
Maps
– is used to perform various activities with the maps.
PFD unit only.
Service
– is a gateway to the service specific settings.
About
– displays information about software and hardware ver-
sion.
Some user options are not shown on secondary Emsis, some options
require password entry before proceeding and some options are avail-
able only when correct hardware is detected.
Figure 12:
Emsis password is required in order to access certain op-
tions
The factory password is
314
, first three most significant digits of
number
π
as seen in Figure 12. The password was introduced in or-
der to prevent unwanted accidental alterations of important settings.
The password cannot be changed.
32
©
Kanardia
2021