Emsis — Manual
7.2
Hardware Tank
4. Make sure the tank is empty and make sure the aircraft is level
as it will be in the flight.
5. Select
T1 Shape
from the
Tank
option in order to open the
tank calibration window. A window similar to Figure 34a is
displayed. Please read the
IMPORTANT
box on the page 65.
6. Press and hold the
OK
button – this opens
Edit Tank
window,
Figure 34b.
(a)
A
Tank
window example.
Yours will be a bit different.
(b)
An
Edit Tank
window exam-
ple. Yours will differ.
Figure 34:
Tank main window and tank edit window examples.
7. The window may show a few measuring points (volume – sensor
pairs). Delete all of them. Select a point, press the
OK
button
and then select
Delete
. Repeat this until all points are deleted.
8. Drain the tank completely.
63
©
Kanardia
2021