Horis User Manual
4.6
Settings
Velocity
Important:
Please make sure that aeroplane is either inside hangar
or there is absolutely no wind and that pitot tube is not covered.
Failing to do so may result in wrong offset and it may worsen airspeed
precision.
•
Rotate the knob and highlight the velocity (airspeed) frame.
•
Push the knob to start editing.
•
Rotate the knob and observe the differential pressure value be-
low. The differential pressure value shall read zero (or almost
zero).
•
Push the knob to finish editing and wait for the timer to close
the window.
4.6.10
Time Zone
Set the local time offset. Positive values are used for countries with
Eastern longitudes, while Western latitudes have negative values.
The time zone is defined combining two values. The first one takes
whole hours and the second is an additional offset given in minutes.
For most part of the world the additional offset is zero and only major
offset is given.
For example, Moscow has local time defined as UTC +3h. In this
case specify 3 for hours and 0 for minutes.
Another example is Adelaide, South Australia. Local time is defined
as UTC+10:30. Here, set hours to 10 and minutes to 30.
Yet another one is Newfoundland and Labrador, where local time is
UTC -2:30. In this case set hours to -2 and minutes to 30.
Horis does not automatically adjust for Summer daylight savings
time.
53
©
Kanardia
2021
Summary of Contents for Horis
Page 2: ......
