Combo — Manual
2.2
Connections
Locate the existing tube, cut it at an appropriate place and insert a
T junction. Install a new tube from junction to the instrument.
It is highly recommended to keep the static tubing as short as pos-
sible. The tubing must avoid sharp bends and twists. The tubing
must be airtight. Water must not be allowed to enter the tubing.
It is strongly recommended to label each tube before connecting to
Indu Combo. This will help a lot if you ever have to remove and
re-install the instrument.
2.2.2
Total Pressure -
Ptot
Indu Combo must be connected to the total pressure source. Total
pressure source is obtained from the total port on the pitot tube.
Same principles as with the static connection apply.
2.2.3
CAN Bus -
CAN
Connection to the CAN bus is optional and is not required for the
normal operation.
Use standard RJ45 ethernet cable to connect it with other
Kanardia
equipment.
When connected to the bus, airspeed, dynamic pressure, standard
atitude, baro corrected altitude, baro correction and static pressure
data will be transmitted to the other units connected on the bus.
2.2.4
Illumination
LCD display brightness level can be adjusted. Here are two options:
new instruments have a push-rotate knob, while older instruments
have only rotating knob. When Indu Combo is connected to the
CAN bus, the knob adjusts brightness of all instruments connected
to the bus.
13
©
Kanardia
2015-2018
