Page 14 of 35
Version 1.5
© KLING & FREITAG GMBH
User's Manual
K&F SPECTRA 212
Use the
point source
mode whenever you want to use the K&F SPECTRA 212 as a single top. This is
regardless of whether or not you use a subwoofer.
For single use, you need to rotate the K&F VariQ unit as appropriate (see chapter "Rotating theVariQ
Unit" on page 14) and to set the switch on the operating panel to the left.
With applications where the audience area is higher than the speaker, you can flip the coverage angle
without rotating the speaker by 180°. In that case, the speaker covers an angle of +25° and –5° at a 10°
upwards pre-tilt.
Terminal, K&F SPECTRA 212:
Before changing the configuration, use the side opening to confirm the current coverage mode of the
K&F VariQ unit.
By rotating the VariQ unit by 90°, you effectively swap the vertical and horizontal coverage angles.
4.1.2
Operating mode: Point source
Switch set to the left
Horizontal beamwidth: 60°
Vertical beamwidth:
30° (-25° to +5°) or
30° (-5° bis +25°)
4.2
Rotating the K&F VariQ Unit
1)
Remove all cabling as necessary and
carefully place the K&F SPECTRA 212
speaker on its backside.
2)
Unscrew and remove the seven grille
screws from both long sides of the
speaker.
Summary of Contents for SPECTRA 212
Page 2: ......
