2
92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 1-800-867-6863 | www.kksound.com
PROCEDURE
Please make sure the area where you want to attach the transducer is dust- and grease free. For
internal mounting, please unscrew casing and slightly sand the gluing area. Wipe the spot where you
will attach the transducer with rubbing alcohol and let dry. Apply super glue to the metal side of the
transducer disc and press on the clean attachment spot.
Attach the mini jack according to illustration.
INFORMATION
Even though the harmonica belongs to the wind instruments group, a class of instruments that are not
naturally apt for transducer application, you will achieve really good results with the Hot Harmonica.
Important:
Please, avoid tapping on the instrument with your fingers while playing, unless you want to
amplify this tapping.
If you need to remove the transducer, hold the pickup in place with your finger and carefully slide a
thin knife blade underneath it to lift the transducer up. Don't use a serrated knife. Any remaining
adhesive can be rubbed or cleaned off.
Important:
Never pull off a transducer by its cable! Use a knife for removal.
TECHNICAL DATA
Transducer Head Diameter: ½”
Height: 1/32”
Impedance: High ohmic
Length of Connection Cable: 1 inch (2.5 cm)
Output: RCA Male
