2
7. Cut off 1/3rd of the gray putty strip.
8. Form a putty-ball and place it on the jig over the saddle
between the high e and b string.
9. Get the Pure pickup and place the jack into the sound hole.
Press one transducer with the golden side up on the putty as
shown in the photo. Make sure the pickup is placed precisely
over the saddle.
10. Make sure the pickup sits absolutely flat and level on the
jig.
11.
This is a very important step!
Remove the golf tee and
hold the jig as shown (between thumb and forefinger on the
headless pin).
The tip of the headless pin must be flush with
the fingertips
. I use my left hand although I'm right-handed but
you may feel more comfortable using your right hand for this.
12. Once you feel confident,
make sure that the putty securely holds the pickup and
apply a generous amount of superglue. Spread it over
the entire golden surface of the transducer.
Be careful not to touch the pickup and superglue after this
step.
Make sure you've practiced the whole procedure before
super-gluing the pickup!