A/C Input
- Connects the amplifier to A/C power via the power cord supplied. Unless otherwise
specified, your amplifier is designed to operate on 120 volts A/C, 60 cycles.
Fuse
- See Fuse Chart
Power Switch
- Turns power on.
Power Selector
- on 50 watt models (2x6L6) the HIGH power mode is 50 watts(class A/B operation).
The LOW power mode is 22 watts (Class A operation.) In 100 Watt models, the High Power is all 4
tubes and the low power is only 2 tubes.
Lead Contour
- This contour control has the same function as the front panel control, but is assigned
to the lead channel only.
.
Speaker Output Jacks
- There are 3 speaker output jacks; 4,8, and 16 ohms. NEVER OPERATE
YOUR AMPLIFIER WITHOUT A PROPER SPEAKER LOAD CONNECTED. Be sure to match the
impedance of your cabinet with the impedance (output) of the amplifier.
Effects Retrn Level
- This control has a pull-bright function. The loop is active in the circuit even with
no effects connected, so the level control acts as a master volume. The pull-bright feature is useful
when playing at low volume (a low fx control setting) or when a large number of outboard efects are
used in the loop, which sometimes causes high frequency insertion loss.
Effects Send
- Use this jack to send the amplifiers signal to outboard effects.
Effects Return
- Use this jack to connect the output of your effects to the amplifier.
Reverb Send-
The reverb drive control adjusts the signal level applied to the reverb unit. Low set-
tings will provide a smooth, short decay effect, simulating small to medium rooms. Higher settings
will increase the decay time. At maximum clockwise rotation, an extremely wet reverb effect can be
created. This control is used in conjunction with the front panel (return) control (see FRONT PANEL
FUNCTIONS, previous page). The reverb effect is defeated with this control in the full counterclock
-
wise position.
S/N
- Your serial number is located here. We strongly suggest that you record this number and have it
handy in case you need service, or in the event that your amp is lost, stolen, or damaged.
Footswitch Jack
- The footswitch connects here. The clean/lead and tone bypass functions can only be
activated via the footswitch.
Rear Panel Functions
AC 100/120/220/230/240 VOLTS
50/60CYCLES
AMP
SLO-BLO
AC
ON
POWER
HIGH
LEAD
CONTOUR
SPEAKER OUTPUTS
FOOTSWITCH
REVERB
SEND
RETURN
LEVEL
EFFECTS LOOP
4 OHM
8 OHM
16 OHM
PULL BRIGHT
FUSE
SEND
RETURN
K&M Analog Designs, LLC
S/N MADE IN USA TWO-ROCK, CA
LOW
RoHs
Compliant
2002/95/EC
