7.
EFFECTS RETURN-
Use this jack to connect the output of your effects to the
amplifier.
8.
EFFECTS LEVEL-
Adjusts the return signal level. It also acts as a master
volume control. Do not set fully counter-clockwise, as this will shut off signal
to the output section, resulting in no output level. Normally this control
should be set at the 12 o’clock position.
9.
FOOTSWITCH JACK-
Connect the foot switch assembly here to enable
remote switching of the lead/rhythm and bypass functions
10.
HARMONICS -
This switch defeats the internal feedback circuit located in
the preamp section. The effect is subtle; you will notice a slight increase in
high and low frequency response and a decrease in dimensionality and
articulation.
NOTE: Both the “Lead” and “Bypass” front panel switches must be
in the “down” position to enable footswitch function.
Page 5
