WORKING WITH THE DEVICE
5
OIL LEVEL INDICATOR
OIL LEVEL INDICATOR
When the oil level falls below the level required for operation, the oil level indicator lights up, and then the engine
stops automatically. The engine will not start until oil is added.
OVERLOAD INDICATOR
OVERLOAD INDICATOR
The overload indicator lights up when the connected generator is overloaded, the inverter control unit overheats or
the AC output voltage rises.
If the overload indicator goes on, the engine will continue to operate, but the generator will no longer produce
electricity. In this case, you must perform the following steps:
AC
AC INDICATOR
INDICATOR
When the generator is running and producing electricity, the AC indicator light is on.
DC PROTECTOR
DC PROTECTOR
The DC protector turns to “OFF” automatically when electric device being connected to the generator is operating
and current above the rated flows. To use this equipment again, turn on DC protector by pressing its button to “ON”.
Reduce the load of the connected electric device below the
specified rated output of the generator if the DC protector turns
off. If the DC protector turns off again, stop using the device
immediately and contact the point of sale and contact your
nearest
K&S Basic TM
Service Center.
IMPORTANT!
When the overload indicator light comes on and power generation stops, proceed as follows:
1. Turn off any connected electric devices and stop the engine.
2. Reduce the total wattage of connected appliance into the rated output.
3. Check for blockages in the cooling air inlet and around the control unit. If any blockages are found, remove.
4. After checking, restart the engine.
The overload indicator may light up within several seconds after
start-up or when connecting electrical devices requiring a high
starting current, such as a compressor or voltage indicator. How-
ever, this is not a malfunction.
IMPORTANT!
EARTHING BOLT
EARTHING BOLT
In all cases, except for an IT system with an insulated neutral wire and bonding, the
generator earthing bolt must be connected to the grounding circuit with a flexible
copper conductor with a cross-sectional area of at least 6 mm
2
.
FUEL TANK CAP
FUEL TANK CAP
Remove the fuel tank cap by turning it counterclockwise
FUEL TANK CAP AIR VENT
FUEL TANK CAP AIR VENT
The fuel cap is equipped with a vent for air supply to the fuel tank. When the
engine is running, the vent must be in the “ON” position (OPEN). This will allow
fuel to enter the carburetor for engine operation. After the generator stops, allow
it to cool down and close the air vent on the fuel cap. When the generator is not in
use, close the vent to the “OFF” position.
koenner-soehnen.com
|
4
