32
DISCONNECT ALL DEVICES BEFORE STOPPING THE GENERATOR!
Do not stop the generator if it has any devices connected to it. This may disable
the generator or devices connected to it!
Use care when the generator is running!
You can use the generator if the voltmeter indicates a value
of 230V ±10% (50 Нz).
TO STOP THE ENGINE, PROCEED AS FOLLOWS:
1. Disconnect all devices connected to the generator, then disable the ECON
mode.
2. Allow the generator to operate at idle for 3 minutes for the alternator to cool
down.
3. Set the engine switch to OFF.
4. Turn the fuel valve to the “OFF” position.
!
!
PLEASE NOTE!
AC OPERATION
Before connecting any devices to the generator, make sure that they are turned
off.
- Before turning on the generator, make sure that all electrical devices, including
wires and plugs, are in good condition.
- After starting the generator, make sure that the voltage indicator (green) goes
on.
- The overload indicator (red) lights up when the connected device is short
circuited or the generated is overloaded (more than 100 W).
- If the oil level is insufficient, the low oil level indicator (yellow) goes on and the
generator stops automatically. If the engine stops or the low oil level indicator
goes on when pulling out the manual starter, check the oil level and top up if
necessary.
- Plug the device’s power cord into an AC outlet, turn on the AC fuse, and turn on
the device.
Make sure the generator is grounded.
If the electrical appliance is grounded, the generator
must also be grounded.
!
!
PLEASE NOTE!
Summary of Contents for KS 1200i
Page 44: ......
