KANE905 Operators Manual
Page 31
9. AVERAGE OF THREE (ITALIAN VERSION ONLY)
STORING
Ensure the instrument is switched on and in the main screen. In the 4-
page mode below.
When you are ready to store the first reading, go into the STORE menu,
use the
and
to find the “Ave Store” item. Press
.
The first sample has been stored.
The screen appears to go back to the main screen but there is a tiny
difference: the right-most column has just one ‘+’ there. The line that it is
on tells you which sample you have got to in the obvious way. Using the
and
keys, you can look at all the usual screens. When you
get to the screen with the fuel you will notice that it is note there. In its
place is a countdown (in seconds). (It started at 120 seconds. While it is
active another sample cannot be stored. This is there to ensure users
cannot take samples any quicker than once every two minutes.
By and by, the countdown will countdown to zero. Then there is a beep
and the countdown line becomes a message saying you can press
when you are ready to store the next sample. In addition, the ‘+’
is now a ’*’. This is visible even if the countdown line is not and is there
to indicate that the instrument is ready to accept the next sample. Once
you have done this, you have stored the second sample.
Repeat for the third and final sample.
Then the instrument returns to its previous state.
It has stored the three samples together with the average thereof in
EEPROM, so it is available again after switching off and on. Only one
such set can be stored at a time.
VIEWING
With the instrument switched on and in the main screen, enter the
STORE menu. Find the “Ave view” item and select if by pressing
