KANE905 Operators Manual
Page 47
D. ELECTROMAGNETIC COMPATIBILITY (CE)
STATEMENT
European Council Directive 89/336/EEC requires electronic equipment
not to generate electromagnetic disturbances exceeding defined levels
and have adequate immunity levels for normal operation. Specific
standards applicable to this meter are stated below.
As there are electrical products in use pre-dating this Directive, they may
emit excess electromagnetic radiation levels and, occasionally, it may be
appropriate to check the meter before use by:
Use the normal start up sequence in the location where the meter
will be used.
Switch on all localized electrical equipment capable of causing
interference.
Check all readings are as expected. A level of disturbance is
acceptable.
If not acceptable, adjust the meter’s position to minimize
interference or switch off, if possible, the offending equipment during
your test.
At the time of writing this manual (July 2015) Kane International Ltd are
not aware of any field based situation where such interference has
occurred and this advice is only given to satisfy the requirements of the
Directive.
This product has been tested for compliance
with the following generic standards:
EN 61000-6-3 : 2011
EN 61000-6-1 : 2007
and is certified to be compliant
Specification EC/EMC/KI/KANE905 details the
specific test configuration, performance and
conditions of use.
