True 4K HDMI 3X1 Switcher
The SW-HD20-3X14K is powered by an external 5VDC power supply included in the
packaging. Before connecting any power supplies, be sure all source and sync devices
interfacing with the SW-HD20-3X14K are powered down and unplugged. Connect
the power supply to the electrical outlet first. Next connect the power jack to the
SW-HD20-3X14K. Finally, connect power to each media source and each HD
display.
Front Panel
1.
‘
POWER
’
LED:
This blue LED illuminates when the device is connected to the
power supply.
2. IN 1, IN2, IN3 LED:
These blue LEDs illuminate when an Input Source is selected.
The Illuminated LED indicates the Input Source being transmitted to the HDMI
output.
3. SERVICE:
This service port is for Manufacturer
’s
use only.
4. IR Receiver:
The IR Receiver interfaces with the included remote control. Connect
the IR Receiver to the
SW-HD20-3X14K
via the 3.5mm jack input
labeled ‘IR.’
Next
secure the IR Receiver end to a visible and open surface using a light adhesive or tape.
Connect the batteries in the remote control. Select the desired input source on the
switcher using your remote control.
NOTE:
Be sure the remote control has direct line of sight to the IR receiver end. IR
requires open line of sight between the remote and the receiver in order to work
properly.
