38
BUCKET BROOM OPERATING INSTRUCTIONS
1. Connect the attachment plate of the loader to the Bucket
Broom frame ensure the quick hitch / attachment locking
pins are engaged.
2. Turn the engine off, move the Aux Lever 3 back and forth to
release hydraulic pressure. Ensure the QRC’s are clean then
connect the hoses of the Bucket Broom to A & B QRC’s on
the right hand side of the loader when looking from the front
of the machine.
3. Connect the hose bracket to the machine and secure the
R Clip.
4. Install the chain onto the broom chain clamp (Supplied with
the Broom) around the top of the lift arm cylinder and tighten
onto the machine.
5. Place the bucket broom
fl
at on the ground and adjust the
chain to have about 4 links slack so when you lift the bucket
up and tilt it forward it will open the bucket lid and empty out
the debris.
6. To Remove the Bucket Broom please reverse the
instructions above.
PLEASE NOTE: ALWAYS FIT THE DUST CAPS PROVIDED FOR
THE QRC’S TO YOUR ATTACHMENT AND MACHINE WHEN
NOT IN USE TO PREVENT DIRT ENTERING THE SYSTEM.
1.
Ensure Lever 3 is in neutral.
2. Start the Engine and adjust the Engine RPM Lever 7 to suit
the operation power you require.
3. Position the Bucket
fl
at on the ground engage Lever 3 and
pull towards the operator. This will start the Broom rotating
and sweeping into the bucket base.
4. The Bucket can either be pulled or pushed with the mini
loader drive system however the does work more ef
fi
ciently
when pulled.
5. Using levers 4 & 5 Drive the machine, Travel Speed is
controlled by levers 4 & 5 by gently engaging both levers
forward, The further forward they are the faster the machine
will travel and slowing down is the exact reverse allowing the
levers to gently return to centre will slow the machine down.
6. To empty debris from the bucket disengage Lever 3 tilt back
slightly and drive to the location you would like to dump the
debris, Raise the lift arm with Lever 2 and tilt the bucket
forward to dump the debris out using Lever 6.
CAUTION:
Prior to commencing work, read the
Safety Rules of this Kanga Loader Manual.
FITTING THE ROTARY HOE
OPERATING INSTRUCTIONS:
Summary of Contents for DW625
