SAFETY WARNING
25
26
Nồi cơm điện
| IH Ri
c
e
c
oo
ker
Nồi cơm điện
| IH Ri
c
e
c
oo
ker
PROBLEM AND METHOD OF SOLVING
Fault
Possible reasons
Coping methods
- Not add water according to the
water level line
- Wrong selection of the function
- There are foreign objects on
the coil plate
- Deformation of the inner pot
- Add water according to the water
level line
- Select the corresponding function
- Remove foreign objects on the
coil plate and cook again
- Contact after-sales to replace the
inner pot
Too soft, too hard,
too thick, too thin,
not cooked, burnt
rice, rice soup
overflowing and
insufficient boiling
Peculiar smell,
discolouration and
dryness during heat
preservation
-The sealing ring and the edge of
the inner pot are mixed with
foreign objects
-Product air leakage
-Too long warm preservation
time
-Remove the foreign objects
-Contact the after sales center to
replace the sealing ring
-It is recommended that
the heat preservation shall be
within 5 hours
Abnormal noises in
the working process
-Water on the inner pot has not
been dried
- On and off sound in the
operation
-Wipe off the water on the inner
pot before using
- Normal phenomenon
Abnormal code
flicking
EU: Communication sending
failure
EU: Pull out and re-connect the
power cord, if the display still
shows the same message, please
send the cooker to your local
after-sales service center for
maintenance.
Abnormal code is
always on
E1: Open circuit of bottom
sensor
E2: Short circuit of bottom
sensor
E3: IGBT sensor open circuit
E4: IGBT sensor short circuit
E5: Open circuit of upper
housing sensor
E6: Short circuit of upper
housing sensor
EU: Communication receiving
failure
C2: IGBT overheating protection
C4: No pot protection
C6: Stepper motor is damaged
C7: Electromagnet is damaged
C2: Check whether the air inlet
and outlet are blocked and
whether the fan rotates smoothly.
Power on after debugging and
send it to the after-sales service
center for maintenance if there is
still a fault.
C4: Check to ensure that the inner
pot is placed and power on. If
there is still a fault, send it to the
after-sales service center for
maintenance.
Other abnormal code: Pull out and
re-connect the power cord, if the
display still shows the same
message, please send the cooker
to your local
after-sales service center for
maintenance.
to avoid burns. Do not touch the hot plate and the product surface by hand.
REPRESENTS [NOTE] MATTERS THAT MAY CAUSE MINOR INJURIES OR
PROPERTY LOSS
- This electric cooker can only be heated with the original inner pot. For
products with metal steamer, the steamer can not be used as a separate
container to avoid overheating, plastic melting or even fire. Do not drop the
inner pot, and do not use hard objects to hit against the inner pot to avoid
deformation. A deformed inner pot must be replaced.
- When operation is being performed or just finished, do not directly touch the
inner cooking pot to avoid burns.
- Improper repair or short-circuiting without permission of some important
accessories including the fuse may lead to protection failure of the appliance
and cause overheating or fire.
- When the appliance is used by persons with cardiac pacemakers or implanted
cochleae, please consult the authorized medical personnel and refer to the
instructions of the medical device provider.
REPRESENTS [GENTLE REMINDER] CONTENT
- Any discrepancy between the picture and the product is subject to the actual
product.
- Before operation, check whether the cooking pot and steam valve are in place
to avoid accidents.
- Before the first usage or after a long time of storage, add water to the steam
water level line, select “Steam” function and steam for one to two times to clean
the interior of the cooker.
- During use, it is normal that the appliance slightly ticks or fizzes. Please do
not panic.
- Do not use the appliance immediately after the first cooking, press the
“Cancel” button and wait above 15 minutes for the heating plate to cool down.
- Do not boil rice with hot water to avoid affecting the judgement of the
temperature control and worsening the result.
- Please regularly clean the steam valve.
- Please regularly clean the table on which the appliance is placed.
- The altitude scope for the appliance to properly function is 0- 2000 m
