5
4
Connect the Control Cable plug from the Upper Tube Handle to the receptacle in
the chassis.
Always
hold the plug
when connecting or disconnecting
the control cable. Pulling on the wire can cause damage.
Remove the black plastic cover from the battery post. Set the battery into the battery tray with
posts to the back of the battery tray. Connect the red clip to the (+) positive terminal and the black
to the (–) negative terminal. If the cables are accidentally reversed, your motocaddie will not
run until the polarity is corrected. (The caddie is equipped with reverse-polarity protection, and
connecting the terminals backwards won’t harm the unit.)
The upper bag support, also referred to as the yoke, is designed to fold up for easy transporta-
tion and storage. Pull it down until it comes to a stop. It can be adjusted to grip your golf bag by
bending the arms open or closed as needed.
The yoke is attached to the upper tubing handle at the best position to hold most golf bags
securely. If you have an unusual bag, or a personal preference for its position, its clamp can be
moved up or down the tubing to any point you like. The yoke is secured with four 5/32” allen-
type machine screws and a suitable wrench is provided with your caddie. Simply loosen the four
screws and adjust the clamps accordingly, then re-tighten securely.
Your Model 5 comes with an assortment of allen-type wrenches. They are provided for adjusting
the upper bag yoke, keeping screws tight, and for adding accessories.
Control Cable
with Plug
Control
Receptacle
Note:
At this point of assembling your caddie for use, establish the
habit of making sure the ON/OFF rocker switch is in the “OFF” position
before connecting your battery cables. (See page 6 photo)
Model 5 Assembly
Your Model 5 is shipped without the rear
wheels attached. See page 9 for assembly
instructions and photo.
Steady the chassis by using the hand-hold,
located in the battery tray. Insert the
Lower
Front Wheel
tube into the hole located in
front of the battery tray.(
shown photo right
)
Insert the
Upper Handle Tube
into the top of chassis just behind the
battery tray. (
Shown photo above
)
Note: To avoid possible breakage,
always
close Drawlatches before
placing chassis into
your car.
Note:
The Handle and Front wheel tubes will
fit in either hole-- therefore be sure the
motor
is on the top right side
, while standing at the
rear of the motorcaddie.
Lower Front
Wheel Tube goes
here
Upper Handle Tube goes here
Battery
Tray
Drawlatch
Base
Latch Keeper
Bracket
Metal Tension Ad-
justment Ring
Drawlatch
(100-140A)
Rear View
Upper Han-
dle Tube
Lower Front
Wheel Tube
