Stretch masking tape across the joint in such a
way as to apply pressure to the joint. Lay the
wing flat.
DO NOT DISTURB THE WING
UNTILL THE EPOXY HAS FULLEY CURED.
FUSELAGE ASSEMBLY
Locate and insert a pin in the firewall on the top
of the fuselage.
Remove the elevators from the stabilizer. Locate
and draw a line down the center of the stabilizer.
Looking through the rudder slot for the line,
center the stabilizer in the fuselage. Using a piece
of string go back and forth between the ends of
the stabilizer adjusting it till it is centered and
square to the fuselage.
DO NOT GLUE
Use a felt tip pen to mark the outline of the
fuselage on both the top and bottom of the
stabilizer. Remove the stabilizer. Cut through the
covering about 1/8-inch inside the lines and
carefully remove the covering exposing the wood.
{
Be careful not to cut into the wood, as this
would weaken the structure
}
4
