Open the elevator and rudder servo holes in the
rear of the fuselage. Test fit your servos and
install the appropriate length extension.
Install the servos following the manufacture
instructions. For the rudder side, fabricate a push
rod by making a “Z” bend 9 ¾-inches from the
threaded end. Install the control horn in such a
way that the clevis holes line up with the hinge
line and the tail wheel tiller arm is pinched.
The elevator push rod is made in the same
fashion. The length for the elevator is 5 ¾-inches.
Mount the control horn 3/16-inch in from the
inside edge of the elevator.
Test fit the aileron servos in the wing. Add the
servo wire extension and use the string to pull
through the wing. Fabricate the push rod by
making a “Z” bend 5-inches from the threaded
end. Mount the aileron bellcrank in the aileron
hard point so the push rod is as straight back as
possible.
Install the throttle servo in the servo tray as
shown. With the servo in the closed position close
the carburetor and fabricate the push rod using a
“Z” bend at each end.
9
