Run the servo wire through the wing and
install the cover with the supplied screws. Drill
and install the shortest control horn in the
aileron. Attach and adjust the linkage.
Open the five holes in the fuselage side
covering. A sharp razor knife works best for
this.
Temporarily install the wing panels. Locate
and drill a hole for the plastic outer throttle
push rod.
Locate and mount the throttle servo and
bracket inside the fuselage. Be sure the servo
and push rod do not interfere with the wing
attach bolts.
Slide the axle through the recessed side of the
wheel. Slide a collar on and tighten the set
screw, leave enough play so thee tire spins
freely.
Install the anti-rotation screw in the wheel
pant followed by the axle wheel assembly.
