21
6.4 Load
LOAD allows you to store an image of a hard drive to a Storage Center.
A Storage Center is a hard drive that has been formatted to store hard drive images. The Storage
Center allows you to quickly and conveniently access common duplication projects. For information
on formatting a hard drive as a Storage Center see section 7.6 Format Source on page 24.
To load an image of a hard drive to a Storage Center:
1. From the Main menu
tap
the ‘SET’ button to navigate to LOAD.
[LOAD ] 000
2. Connect your Storage Center hard drive to the side of duplicator labeled “SOURCE”.
3. Connect the Master hard drive to the side of duplicator labeled “TARGET”.
4.
Tap
the ‘RUN’ button to begin the load process.
Note:
If the screen displays the message “SOURCE NOT FORMATTED” it means that the
hard drive connected to the Source side has not been formatted as a Storage Center.
Tap
the
‘RUN’ button to format the hard drive connected to the Source side as a Storage Center or
tap
the ‘SET’ button to cancel.
5. The duplicator will ask you to input a file name for the image. Enter a file name:
Please Input
>[000] SEL IMG FILE
a) The file name consists of three digits. The digit furthest to the right will be blinking, indicating
that it is currently selected.
Tap
the ‘RUN’ button to increase the value by one.
b)
Tap
the ‘SET’ button to select the next digit to the left.
Tap
the ‘RUN’ button to increase the
digit by one. Repeat this step as necessary.
6. When you have completed naming the image file,
hold
the ‘RUN’ button and the load process
will begin.
Note:
If the image file name you entered is already being used by another image file, the system
will ask you to confirm overwriting the previously saved file.
Tap
the ‘RUN’ button to confirm
or
tap
the ‘SET’ button to cancel.
[LOAD ]001
15.94G
33.44%
Total data to be loaded
IMG file number
Percentage completed
Load
