16
5. DUPLICATION
The KanguruClone HDD Duplicator can operate in either one of two duplication methods:
•
With a Master HDD as the source
•
With a Storage Center as the source
Both methods are described in the following sections.
5.1 Duplicating From a Master HDD
Using a Master HDD as the Source is the simplest and most convenient way to perform the duplication
process.
IMPORTANT!
Connect all Master and Target hard drives before you execute an operation.
To execute the duplication of a Master HDD:
1. From the Main menu,
tap
the ‘SET’ button to navigate to the desired copy mode. For more
information on the different available copy modes see chapter 3. Duplication Modes on page
13.
The screen will display the following:
Current Copy Mode
Number of Targets connected
Total successful copies
Total failed copies
Note:
The system will not recognize any connected drives before duplication begins. Therefore
the “Number of Targets connected” value will always be zero until you execute the copy process.
2. Once you have selected the desired copy mode,
tap
the ‘RUN’ button to execute. The duplication
process begins as the system initializes the connected disks. At this point the system will be able
to display the number of connected targets correctly.
(Continued on next page)
Duplicating From a Master HDD
