34
8.12 Max UDMA Mode
The MAX UDMA MODE option allows you to configure the maximum transfer speed allowed.
Tap
the ‘RUN’ button to change this option. The MAX UDMA MODE can be set as 0 – 6. The MAX
UDMA MODE is set to 6 by default.
8.13 Skip Read Error
The SKIP READ ERROR option allows you to enable or disable error skipping during FULL,
SMART, BRIEF and RESIZE modes.
Tap
the ‘RUN’ button to change this option.
•
[ ]
– Disabled (default). When an error is detected while reading from the Source, the duplicator
will cancel the current process.
•
[
٭
]
– Enabled. When an error is detected while reading from the Source, the duplicator will
skip the bad sector on the Source and fill it with a zero on the Target.
8.14 Source Power Off
The SOURCE POW. OFF option allows you to configure whether the system turns off the power to
the hard drive connected to the Source port when a copy process is completed.
Tap
the ‘RUN’ button
to change this option.
•
[
٭
]
– Enabled (default). When a copy operation is completed the power to the hard drive
connected to the Source port is turned off.
•
[ ]
– Disabled. When a copy operation is completed the power to the hard drive connected to
the Source port remains on until you change copy modes.
8.15 Load Full Image
The LOAD FULL IMAGE option allows you to control how image files are saved to a Storage Center
during a Load operation (see section 6.4 Load on page 24).
Tap
the ‘RUN’ button to change this
option.
•
[ ]
– Disabled (default). The system will analyze the Source’s file system before building the
image. If the Source’s file system is recognized as FAT/ NTFS/ EXT1/ 2/ 3/ 4, the image will be
a Brief image based on the file system and data area. If the Source’s file system is unrecognized
the image will be a Full sector by sector image.
•
[
٭
]
– Enabled. When executing a Load process, the system will not analyze the Source’s file
system and will automatically build the image sector by sector.
Max UDMA Mode / Skip Read Error / Source Power Off / Load Full Image
