24
4.14 System Info
SYSTEM INFO allows you to view information regarding your duplicator’s firmware version and
build number.
To view the system information:
1. From the SETUP menu, press the
UP
or
DoWN
button to navigate to the SYSTEM INFO
function.
2. Press the
ENT
button to begin viewing information for your duplicator:
KANGURU DUPLICATOR
VER: 4.03 BLD:0407
3. Press
the
ESC
button to exit to the Setup menu.
4.15 Total Copy Count
TOTAL COPY COUNT keeps track of the total number of successful and unsuccessful duplications
produced by the system. This is a running count that includes all copy modes.
1. From the SETUP menu, press the
UP
or
DoWN
button to navigate to the TOTAL COPY
COUNT function.
2. Press the
ENT
button to view the copy counts:
Total Pass: 00000114
Total Bad : 00000006
3. Press
the any button to exit to the Setup menu.
4.16 Set to Default
SET TO DEFAULT allows you to restore all settings back to their factory default values.
To reset your duplicator to its original default configuration:
1. From the Setup menu, press the
UP
or
DoWN
button to navigate to the SET TO DEFAULT
function.
2. Press the
ENT
button. The screen will display a message asking you to confirm the reset. Press
the
ENT
button to confirm, or press the
ESC
button to cancel.
ARE YOU SURE?
ESC->NO, ENT->YES
3. Once the reset has been completed, you will be displayed a confirmation message on the screen.
Press any button to return to the Setup menu.
System Info / Total Copy Count / Set to Default
